RØDE VideoMic Pro Shotgun Microphone

Pin It

Price List USD 360
RØDE VideoMic Pro Shotgun Microphone
The RØDE VideoMic Pro is a true shotgun microphone designed for use with camcorders, DSLR cameras and portable audio recorders as a source of primary and reference audio.
At the heart of the VideoMic Pro is a high resolution 1/2" condenser capsule that provides broadcast quality audio via a 3.5mm minijack connector (outputting the mono signal to both left and right channels). A super-cardioid polar pattern ensures that surrounding audio is minimised, and your recording is focused on the subject in front of the camera.

An innovative suspension system separates the VideoMic Pro capsule and electronics from its mount, providing isolation from external physical factors that may cause unwanted rumble and vibrations in the microphone. A lightweight and flexible yet robust multi-strand cable provides significantly lower noise transference than traditional audio cable while ensuring a high definition signal.

Easily accessible on the rear face of the microphone are the power, filter and level controls. In addition to the microphone's native 40Hz-20kHz response a selectable high-pass filter at 80Hz is available, which will prevent low end noise such as air conditioners and traffic from being recorded.

Below these controls are the level settings, which attenuate or boost the recorded level as required. The -10dB level attenuation (or PAD) is ideal for recording loud sound sources, such as live music, motorsport, or interviews where the subject is very close to the camera. The +20dB level boost is designed for use with DSLR cameras such as the Canon 5DMkII, Canon 7D, Canon 1D, Canon 550D/T2i, Canon 60D, Nikon D7000, Nikon D5100, Panasonic GH1 and Panasonic GH2. This boost in the microphone output allows the user to reduce the camera's preamp level (or mic-input level), effectively reducing the amount of noise generated by the camera's comparatively low quality audio circuitry.

The microphone uses a standard sized shoe mount for on camera use, and features a 3/8" thread in the base of the mount for easy boom pole mounting. Note that cameras with proprietary shoe mounts will require an adaptor or alternative mounting solution.
The VideoMic pro is battery powered, and provides over 70 hours recording from a single 9V battery.

Specification:

Acoustic Principle	Line Gradient
Active Electronics	JFET impedance converter
Capsule	0.50"
Polar Pattern
Address Type	End
Frequency Range	40Hz - 20kHz
Output Impedance	200Ω
Maximum SPL	134dB SPL (@ 1kHz, 1% THD into 1KΩ load)
Maximum Output Level	6.9dBu (@ 1kHz, 1% THD into 1KΩ load)
Sensitivity	38.0dB re 1 Volt/Pascal (12.60mV @ 94 dB SPL) +/- 2 dB @ 1kHz
Power Options	(Over 70 hours operation from 9V alkaline battery)
Weight	85.00gm
Dimensions	95.00mmH x 43.00mmW x 150.00mmD
Output